Price: $44.20
Rust-Oleum Automotive Truck Bed Coating Spray is a textured finish that forms to the contours of a truck bed. Ideal for recoating and restoring worn, unfinished or previously finished metal truck beds. The advanced formula helps prevent truck bed damage caused by scratches, rust and weather. Also ideal for running boards, bedrails and more. Use outdoors or in a well-ventilated area.
Ideal for use on truck beds, trailer floors, fenders and other metal surfaces
Stops Rust formula provides long lasting protection with any-angle spray comfort tip that reduces finger fatigue and makes it easy to reach hard to paint places
Dries to the touch in 1 hour and covers up to 20 sq. ft. per can
Offers superior durability and can be used on bare or primed metal truck beds
Textured non-skid finish is resistant to scratches and the outdoor elements
Customer Reviews
Reviewer: SClin
Rating: 5.0 out of 5 stars
Title: Great product, great price
Review: I purchased a case of Rust-Oleum Bed Liner, the product did a great job for the project I had for my truck. Make sure you prep the area you are going to coat well by sanding/scuffing the area then applying some kind of primer/filler to the area as well. It dries fast which I say to touch like 30mins, did apply 3 coats for the best results. I do say make sure there is open air flow due to the overwhelming smell of the spray. Spraying was easy just make sure to give some distance also use full motion back and forward best results if not will give you drip spots. Itâs not to rough so easy to wash.Will I buy again for more things on my truck yes I will, the only down side was 2 cans did explode in delivery of the product. Rust-Oleum did a great job about refunding my money equivalent to the lose product I did received.
Reviewer: David Coomes
Rating: 5.0 out of 5 stars
Title: Worked like a champ
Review: Had a jeep with rusted out rocker panels. Stripped out most of the rust including grinding the surface rust. Then rednecked the rocker panels using chicken wire and spray foam. After shaping them used this to seal and color the previously damaged area including putting a coat over the sun bleached trim. Not a smooth gloss paint job but for a jeep that will be being beat up on the trails looks real good.
Reviewer: XxExpert ReviewerxX
Rating: 5.0 out of 5 stars
Title: Looks good
Review: It sprays on nice and heavy but you may want to keep a rag handy because the paint gets accumulated on the nozzle and drips if you dont keep it clean or the nozzle may clog itself if you let the spray sit just a few minutes like mi e did. I did 2 coats on a little 6ft nissan hardbody bed with 2 cans, but ran out on the sides of the bed. I think 3 cans is good for that. If this lasts, I am going to do my full size 6ft bed on my truck. I am guessing that would be 4 or 5 cans for 2 coats which is what the can says to do.
Reviewer: DAVE E.
Rating: 4.0 out of 5 stars
Title: Excellent value for cheap jobs, but spray heads SUCK!
Review: On 7/27/16 I bought 2 of these cans on Amazon for $6.50 each as an âAdd-Onâ to use on PRIMED PLYWOOD.First, RUST-OLEUM SUCKS FOR NOT FIXING THE SPRAY CLOGGING ISSUES!!!!I am making an 8â high (above wheel wells) false bed, which extends over the open tail gate, for my 2009 Nissan Crew Cab. This is for 2 reasons.1. Sleep 2 people comfortably.2. Wheel wells prevent efficient packing of the vehicle, particularly with Costco/Home Depot storage tubs. Now I can pack up to 14 pre-organized and labeled camping storage tubs (7 on 7) perfectly, within 5 minutes while packing long things like poles, tools, rods and chairs underneath the false bed. Ratchet strapping is now simple, fast and requires no bungees.1. I bought some 3/8â plywood. Home Depot recommended I used Kilz2 ($17) to prime it.2. I applied 2 heavy coats on the top and 1 on the bottom using 3/4 of a gallon.3. I allowed the paint to set 2 days between coats. Have no idea if that matters.On 8/29/16, today, I used the first two 15oz cans of Rust-Oleum Truck Bed Coating.1. I first weighed both cans without the caps. Can1 = 19oz, Can2 = 19.2oz.2. I used a Rust-Oleum Comfort Grip trigger ($6) which I already happened to have. Having read 90% of all of these reviews, there was no possible way I was going to attempt to use this stuff without a spray trigger.3. I shook both cans at least 4 minutes each over 1.5 hours as I did other stuff. I have no idea if that helped, but I was not taking chances.4. When I began painting it was 87F with 16% humidity.5. CAN1 began sputtering immediately. I kept shaking it upright while I sprayed and did not get any drops until about half way when it started sputtering again. I then turned the can upside down and the spray became very smooth and I did not have to shake it at all, but then drops started falling and became worse as the can emptied. SEE PIC. When the paint ran low, I began doing the 3/8â sides so I could continue painting.6. CAN2 began sputtering immediately and I immediately turned it upside down when I began spraying resulting in paint drops again, but no shaking was necessary. The paint drops are of no consequence whatsoever for this project and will be hidden by the second coat. When the paint ran low, I had to stand the board up to continue.7. Two cans barely covered the 57âx80â (32sf) surface and 3/8â sides in a splotchy manner with numerous small areas not fully coated. 3 cans were required. It will take a minimum of 3 cans to do a second coat correctly.8. After using every possible drop I could, can 1 weighed 4.5oz and can 2 weighed 4.3oz for a net usable amount of 14.5oz and 14.9oz respectively. Woo hooooo!!!9. I compared the grit on the finish with 60/80/100/120/150/240 sandpapers that I had on hand. It was very hard to compare since the painted grit was much more sparse than sandpaper. My best guess would be equivalent to between 80-100 grit.10. This stuff does not compare in any way to the stuff sprayed professionally in truck beds. However, itâs so cheap that you should consider carefully whether you need the professional spray job or the better brush/roll-on versions.TIPS:1. USE A GOOD SPRAY CAN TRIGGER!!! They work great upside down too. I did not get a single drop of paint on my latex gloves while spraying despite shaking the can, and with drops falling.2. Spray the downward area of the item first. Then when the can starts sputtering, you can level the can out towards the sides and effectively use more paint.3. A can might cost you up to a $1 more at Home Depot or Walmart. So donât worry about under-ordering.*** 30 August 2016; UPDATE/CORRECTION ***I bought an additional 4 cans from my local Home Depot at $7.46 ea, before 10% military discount, for a total of 6 cans, the last one for touch ups.The 6 cans weighed an average of 18.98oz before using (without cap) and ranged from 8.7 to 9.3oz. The 5 used cans weighed an average of 4.2oz after using as much as possible for a net average of 14.84oz of paint per can.When I began painting tonight, it was 88F and 24%RH.CAN3: I neglected to turn the cap to the front after shaking it and began spraying inside the trigger housing. Bummer. I had to clean it up real quick before starting again. I turned it upside down to spray and it began sputtering badly. I turned it back upright and it began spraying smooth until it got down to about 50-60% and then I had to shake it up and down every 10 seconds or so at decreasing intervals.CAN4 worked the same as Can3.CAN5 worked the same also except that it had a much, much better black matte finish then the other 2 cans, which is good because I over sprayed with Can3, and it ran, and was too glossy.TIP 4: How your cans perform depends on the batch, which depends on where you bought it.
Reviewer: Jimmy
Rating: 5.0 out of 5 stars
Title: I put that stuff on everything
Review: I painted bumpers of my old truck and they looked new. Had left over so I painted the plastic headlight surrounds and plastic grill and they looked brand new, painted the old metal frame on gate and it looked new, painted old metal basketball pole and made it look new. Very easy to spray, you have to make a big error for it to run. I painted bumpers more than a year ago and they still look great.
Reviewer: Lou
Rating: 5.0 out of 5 stars
Title: Well worth it
Review: Bought a 2022 Colorado with 14k but the bed was all scratched. It made it look new with a nice coating.
Reviewer: wow can u hook up stars
Rating: 5.0 out of 5 stars
Title: Rims
Review: My Lexus rims are 21 years old and painted them with silver and looked nice the got bad so went to this textured paint and love it and did grill too
Reviewer: denis morin
Rating: 5.0 out of 5 stars
Title:
Review: dispandeux fait la job
Reviewer: jacoby
Rating: 5.0 out of 5 stars
Title:
Review: Perfecto
Reviewer: Denis Lapointe
Rating: 5.0 out of 5 stars
Title:
Review: Good product
Reviewer: Mh
Rating: 3.0 out of 5 stars
Title:
Review: Good quality, but itâs not effective, easy to scratch. To expensive, and it doesnât cover much per can
Reviewer: Amazon Customer
Rating: 5.0 out of 5 stars
Title:
Review: yes good product not OEM quality but great for touch upsI would order again
