Product Description
CAR DUSTPROOF TIE ROD BOOTS SET
The invisible guard that guards your car!
DAMPING AND NOISE REDUCTION
● The dust cover can play a role in damping and noise reduction, providing a smoother driving experience
PROTECTING THE BEARINGS
● The dust cover keeps the grease from being thrown out and also keeps sand and dust from getting inside the cage and causing it to wear out. This is especially important for cage maintenance
APPLICABLE RANGE
● 0.39″ 0.78″ 1.1″ 1.37″ 1.25″ 1.49″ 1.65″ 1.77″ (The inner diameter of the product is the actual range of use)
ALL-AROUND DUST PROTECTION
Silicone is a tough and flexible material that fits snugly into the tie rods, effectively blocking out moisture, dust and debris.
INSTALLATION STEPS
How to replace steering rack boot?
1. First of all, you need to locate the rack and pinion bellow, which is usually located underneath the steering wheel, where it connects to the steering column and steering gear
2. Before removing it, it’s a good idea to take photos or videos so that it can be restored correctly when installing the new dust cover. Also, make sure you place the vehicle on a flat surface and tighten the handbrake
3. Next, the steering wheel needs to be removed. This usually involves unscrewing the safety bolts using a wrench. The steering wheel can then be removed
4. Once the steering wheel is removed, you can see the dust cover for the steering wheel. This part is usually made of plastic and can be removed by pulling down. If it is stuck, try gently pushing it in one direction until it can move freely
5. Once the old dust cover is removed, the new one can be installed. Slide the new dust cover over the steering column, which can be secured using tie wraps and clamps
6. Once the new dust cover is secured, begin reassembling the vehicle. First, return the steering wheel to its original position and tighten the security bolts with a wrench. Then, return the vehicle to its original position and check that all connections are secure
7. Finally, start the vehicle and test the steering system. If any problems are found, further inspection and repair may be required
Note:
1. The real color of the item may be slightly different from the pictures shown caused by many factors such as brightness of your monitor and light brightness
2. Please allow slight manual measurement deviation for the data
Important Size: The steering boot is 8.85 inch in length, the small port outer diameter is 0.42 inch, inner diameter is 0.39 inch, the large port outer diameter is 1.34 inch, inner diameter is 1.25 inch, please check the size data you need before purchasing
All-around Dust Protection: Silicone is a tough and flexible material that fits snugly into the tie rods, effectively blocking out moisture, dust and debris and protecting gears, racks and other steering components from damage
Wide Application: This tie rod boots has a lot of different caliber specifications, including inner diameter: 0.39″ 0.78″ 1.1″ 1.37″ 1.25″ 1.49″ 1.65″ 1.77″, can be cut to size according to different owners’ needs, suitable for most cars and trucks
Installation Steps: First, you need to locate the rack and pinion bellows, then pull the old tie rod end boot down to remove it, then the new dust cover is slid onto the steering column, and you can adjust the position slightly with your fingers or tools
Full Accessories: Our rack and pinion boot kit contains 2 piece inner tie rod boot, 6 tie wraps and 2 locking clamps, fully equipped! The steering rack boot is made of selected high-grade silicone material with excellent wear-resistance
Price: $13.99
(as of Feb 12, 2025 04:40:14 UTC – Details)
